Aprilia Arrecife 200 Fault Codes
Aprilia Arrecife 200 motorcycles have engines, which are made up of many different parts. These parts must work together in order for the engine to function. A problem with one of the parts can make the engine not run. There are many different parts that make up an engine. The following aprilia arrecife 200 faults are the list of some of the parts of a motorcycle engine.
The oil level of Aprilia Arrecife 200 should be the same level in the dipstick, even when the engine is cold. You can check the oil level by removing the dipstick, holding the dipstick in your hand, and then reinserting the dipstick. Then, you’ll be able to see where the oil level is.
Aprilia Arrecife 200 Faults :
Your bike engine consists of a great deal of elements like the casting, cylinder heads and pistons. it's necessary to form certain these area unit all clean and lubricated to avoid engine issues. Conjointly keep in mind that Aprilia Arrecife 200 motorbike engine could be a terribly delicate piece of machinery therefore it is best to handle it with care.
Aprilia engine management system is able to self-diagnose faults and tell you what's wrong with it.
To display the Aprilia Fault Codes diagnostics codes, enable diagnostics mode by pressing the LAP button at key-ON for at least 15 seconds. To exit the diagnostics code display and return to the normal display mode, run a key-OFF/ON cycle. When the faults are eliminated and hence the Fault Code is no longer being sent to the dashboard by the ECU, the dashboard will continue to display them until a key-OFF/ON cycle is run. lithe dashboard is sent a code other than those given in the following diagnostics code table, it will display PXX where the XX ls the last iwo digits of the code in question. lf the CAN line does not respond or is disconnected in diagnostics mode, ERR will flash in place of the code digits
Aprilia Error Code List :
| Component | Fault Code DTC | Possible Cause |
|---|---|---|
| Camshaft position sensor | 11 |
Sensor not connected.
Sensor broken. Wiring faulty. |
| Crankshaft position sensor | 12 | |
| Intake pressure sensor | 13 | |
| Intake pressure sensor | 14 | Excessive pressure difference between two pressure sensors |
| Throttle position sensor | 15 |
Sensor not connected.
Sensor broken. Wiring faulty. |
| Coolant temperature sensor | 21 | |
| Air temperature sensor | 22 | |
| Atmospheric pressure sensor (inside ECU) | 23 | Sensor faulty |
| Ignition coil 1, Front cylinder | 33 | Ignition coil faulty or wiring not connected |
| Ignition coil 2, Front cylinder | 34 | |
| Ignition coils 1 and 2, Front cylinder | 33,34 | |
| Ignition coil 1, Rear cylinder | 35 | |
| Ignition coil 2, Rear cylinder | 36 | |
| Ignition coils 1 and 2, Rear cylinder | 35,36 | |
| Fall Sensor (tip-over sensor) | 41 |
Sensor not connected.
Sensor broken. Wiring faulty. |
Aprilia ECU Error Codes
This menu allows you to view any current errors (active) or stored (memo) as detected by the ECU. The presence of an error is indicated by x. To identify the error, please refer to the ECU error codes table.
| ERROR DESCRIPTION | ECU ERROR CODE |
|---|---|
| Engine overheat | ECU 01 |
| Pick-up sensor failure | ECU 02 |
| Wrong signal from throttle position sensors | ECU 03 |
| Wrong signal from throttle position sensor 1 | ECU 04 |
| Wrong signal from throttle position sensor 2 | ECU 05 |
| Throttle position sensor 1 malfunction | ECU 06 |
| Throttle position sensor 2 malfunction | ECU 07 |
| Throttle position sensors malfunction | ECU 08 |
| Incorrect charging voltage | ECU 09 |
| Oil pump malfunction | ECU 10 |
| Air injector malfunction | ECU 11 |
| Fuel injector malfunction | ECU 12 |
| Ignition circuit malfunction | ECU 13 |
| Fuel pump malfunction | ECU 14 |
| Engine rpm limiter tripped | ECU 15 |
| Error in ECU power supply | ECU 16 |
| Rpm limiter tripped while starting | ECU 17 |
| Engine temperature sensor malfunction | ECU 18 |
| Error on ECU throttle sensor connection | ECU 22 |
| Atmospheric pressure sensor malfunction | ECU 23 |
Aprilia Instrument Panel Error Codes :
| ERROR DESCRIPTION | INSTRUMENT PANEL ERROR CODE |
|---|---|
| Immobilizer failure: Key code read but not acknowledged | DSB 01 |
| Immobilizer failure: Key code not read (key not available or transponder broken) | DSB 02 |
| Immobilizer failure: Broken antenna (open or short-circuited) | DSB 03 |
| Immobilizer failure: Inner controller failure | DSB 04 |
| Fuel sensor failure | DSB 05 |
Aprilia Arrecife 200 Motorcycle Problems :
- Aprilia arrecife 200 after fire
- Aprilia arrecife 200 air cleaner clogged, poorly sealed, or missing
- Aprilia arrecife 200 air cleaner element clogged
- Aprilia arrecife 200 air duct loose
- Aprilia arrecife 200 air suction valve trouble
- Aprilia arrecife 200 air switching valve trouble
- Aprilia arrecife 200 backfiring when deceleration
- Aprilia arrecife 200 cracked or obstructed intake air pressure sensor
- Aprilia arrecife 200 crankshaft sensor trouble
- Aprilia arrecife 200 eCU ground and power supply trouble
- Aprilia arrecife 200 eCU trouble
- Aprilia arrecife 200 engine overheating - Water temperature sensor or crankshaft sensor trouble
- Aprilia arrecife 200 engine stalls easily
- Aprilia arrecife 200 engine vacuum not synchronizing
- Aprilia arrecife 200 exhaust Smokes Excessively
- Aprilia arrecife 200 firing incorrect
- Aprilia arrecife 200 fuel filter clogged
- Aprilia arrecife 200 fuel injector clogged
- Aprilia arrecife 200 fuel injector O-ring damage
- Aprilia arrecife 200 fuel injector trouble
- Aprilia arrecife 200 fuel line clogged
- Aprilia arrecife 200 fuel poor quality or incorrect
- Aprilia arrecife 200 fuel pressure regulator trouble
- Aprilia arrecife 200 fuel pressure too low or too high
- Aprilia arrecife 200 fuel pump bearings may wear. Replace the fuel pump
- Aprilia arrecife 200 fuel pump not operating
- Aprilia arrecife 200 fuel pump operates intermittently and often DFI fuse blows
- Aprilia arrecife 200 fuel pump relay trouble
- Aprilia arrecife 200 fuel pump trouble
- Aprilia arrecife 200 fuel/air mixture incorrect
- Aprilia arrecife 200 fuel/air mixture incorrect
- Aprilia arrecife 200 gear position sensor, starter lockout or side stand switch trouble
- Aprilia arrecife 200 inspect and repair or replace
- Aprilia arrecife 200 intake air pressure sensor trouble
- Aprilia arrecife 200 intake air temperature sensor trouble
- Aprilia arrecife 200 intake air temperature sensor trouble
- Aprilia arrecife 200 intermittent any DFI fault and its recovery
- Aprilia arrecife 200 little fuel in tank
- Aprilia arrecife 200 main throttle sensor trouble
- Aprilia arrecife 200 no or little fuel in tank
- Aprilia arrecife 200 poor acceleration
- Aprilia arrecife 200 spark plug burned or gap maladjusted
- Aprilia arrecife 200 spark plug dirty, broken or gap maladjusted
- Aprilia arrecife 200 spark plug incorrect
- Aprilia arrecife 200 spark weak
- Aprilia arrecife 200 stick coil shorted or not in good contact
- Aprilia arrecife 200 stick coil trouble
- Aprilia arrecife 200 subthrottle sensor trouble
- Aprilia arrecife 200 subthrottle valve actuator trouble
- Aprilia arrecife 200 throttle body assy dust seal damage
- Aprilia arrecife 200 throttle body assy holder loose
- Aprilia arrecife 200 throttle valves will not fully open
- Aprilia arrecife 200 unstable (rough) idling
- Aprilia arrecife 200 unstable fuel pressure
- Aprilia arrecife 200 vacuum hose
- Aprilia arrecife 200 vehicle-down sensor trouble
- Aprilia arrecife 200 water or foreign matter in fuel Change fuel
- Aprilia arrecife 200 water temperature sensor trouble
The first sign that your Aprilia Arrecife 200 motorcycle's starter system is working well is the warning light that appears when you switch on the ignition. It will illuminate for a few seconds, and then go out. This is a good sign that your starter system is working properly and you'll be able to start your motorcycle without difficulty.
Possible Failure Types :
- Strange Aprilia Arrecife 200 engine noise.
- Aprilia Arrecife 200 fog from engine.
- Strange Aprilia Arrecife 200 engine noise.
- Aprilia Arrecife 200 Vibrations and Rattling
- Aprilia Arrecife 200 Loud Acceleration
- Aprilia Arrecife 200 rusty exhaust
- Aprilia Arrecife 200 blockages in exhaust pipe
- Aprilia Arrecife 200 wear and tear exhaust
Aprilia was founded directly after WW2 as a manufacturer of bicycles, moving to scooters and motorcycles in 1968. Today, Aprilia enjoys success in the competitive sports and adventure bike segments, as well as competing in a variety of motorcycle racing championships.
Check other Aprilia fault codes.Common abbreviations and their meanings below:
ABS: Anti-Lock Braking System ACR: Automatic Compression Release AFR: Air Fuel Ratio AIS: Active Intake Solenoid ATS: Air Temperature Sensor BAS: Bank Angle Sensor BCM: Body Control Module CAN: Controller Area Network CCM: Cruise Control Module CKP: Crank Position Sensor DLC: Datalink Connector DTC: Diagnostic Trouble Codes ECM: Electronic Control Module ECT: Engine Coolant Temperature ECU: Electronic Control Unit EFI: Electronic Fuel Injection EFP: Electronic Fuel Pump ET: Engine Temperature sensor FI: Fuel Injectors FPR: Fuel Pressure Regulator H-DSSS: Harley-Davidson® Smart Security System HCU: Hydraulic Control Unit, ABS HFSM: Hands Free Security Module HO2S: Heated Oxygen Sensor IAC: Idle Air Control actuator IAT: Intake Air Temperature sensor ICM: Ignition Control Module IMAP: MAP + IAT in one unit ISS: Ion Sensing System JSS: Jiffy Stand Sensor LHCM: Left Hand Control Module MAP: Manifold Absolute Pressure sensor MHR: Right Hand Control Module RCM: Reverse Control Module TCA: Throttle Control Actuator TGS: Twist Grip Sensor TMAP: Intake Air Temperature / Manifold Absolute Pressure equipment TPS: Throttle Position Sensor TSM / TSSM: (Turn Signal / Turn Signal Security Module) VE: Volume Efficiency VIN: Vehicle Identification Number VSS: Vehicle Speed Sensor WSS: Wheel Speed Sensor
These abbreviations, and the accompanying list of trouble codes, can be a great start when your Aprilia check engine light comes on. As mentioned above, if you are not comfortable with electrical diagnostic work, a dealership or qualified technician can offer assistance. Please keep in mind that even though you have the ability to clear a DTC using the onboard diagnostic feature, you shouldn't clear the code prior to your service appointment. Let the technician view and clear the codes as they troubleshoot the issue.
Aprilia and logo are registered trademarks of Aprilia. We are fan of MOTORCYCLES ! We love them.