Aprilia Climber 280 R Fault Codes

Aprilia Climber 280 R motorcycles have engines, which are made up of many different parts. These parts must work together in order for the engine to function. A problem with one of the parts can make the engine not run. There are many different parts that make up an engine. The following aprilia climber 280 r faults are the list of some of the parts of a motorcycle engine.

Begin by checking Aprilia Climber 280 R level and adding more, and then see what happens. Another possibility is that your master cylinder is affected by leaks or air bubbles. You may need to have this part replaced to fix it. What can I do when the Aprilia Climber 280 R brakes lock up while I’m riding? This can be a serious situation, so don’t hesitate to call for a tow truck. The problem could be a problem with your master cylinder.

Aprilia Climber 280 R Faults :

Another drawback that may occur along with your bike engine could be a blown gasket. this will cause your engine to overheat and presumably crack the cylinder heads. during this case, it's best to require your Aprilia Climber 280 R bike to an expert mechanic to possess it verified. Another common drawback is with the carburettor. The carburettor is that the a part of your bike that mixes air and fuel to make the combustion required to power the engine.

Aprilia engine management system is able to self-diagnose faults and tell you what's wrong with it.

To display the Aprilia Fault Codes diagnostics codes, enable diagnostics mode by pressing the LAP button at key-ON for at least 15 seconds. To exit the diagnostics code display and return to the normal display mode, run a key-OFF/ON cycle. When the faults are eliminated and hence the Fault Code is no longer being sent to the dashboard by the ECU, the dashboard will continue to display them until a key-OFF/ON cycle is run. lithe dashboard is sent a code other than those given in the following diagnostics code table, it will display PXX where the XX ls the last iwo digits of the code in question. lf the CAN line does not respond or is disconnected in diagnostics mode, ERR will flash in place of the code digits

Aprilia Error Code List :

Component Fault Code DTC Possible Cause
Camshaft position sensor 11 Sensor not connected.

Sensor broken.

Wiring faulty.

Crankshaft position sensor 12
Intake pressure sensor 13
Intake pressure sensor 14 Excessive pressure difference between two pressure sensors
Throttle position sensor 15 Sensor not connected.

Sensor broken.

Wiring faulty.

Coolant temperature sensor 21
Air temperature sensor 22
Atmospheric pressure sensor (inside ECU) 23 Sensor faulty
Ignition coil 1, Front cylinder 33 Ignition coil faulty or wiring not connected
Ignition coil 2, Front cylinder 34
Ignition coils 1 and 2, Front cylinder 33,34
Ignition coil 1, Rear cylinder 35
Ignition coil 2, Rear cylinder 36
Ignition coils 1 and 2, Rear cylinder 35,36
Fall Sensor (tip-over sensor) 41 Sensor not connected.

Sensor broken.

Wiring faulty.

Aprilia ECU Error Codes

This menu allows you to view any current errors (active) or stored (memo) as detected by the ECU. The presence of an error is indicated by x. To identify the error, please refer to the “ECU error codes” table.

ERROR DESCRIPTION ECU ERROR CODE
Engine overheatECU 01
Pick-up sensor failureECU 02
Wrong signal from throttle position sensorsECU 03
Wrong signal from throttle position sensor 1ECU 04
Wrong signal from throttle position sensor 2ECU 05
Throttle position sensor 1 malfunctionECU 06
Throttle position sensor 2 malfunctionECU 07
Throttle position sensors malfunctionECU 08
Incorrect charging voltageECU 09
Oil pump malfunctionECU 10
Air injector malfunctionECU 11
Fuel injector malfunctionECU 12
Ignition circuit malfunctionECU 13
Fuel pump malfunctionECU 14
Engine rpm limiter trippedECU 15
Error in ECU power supplyECU 16
Rpm limiter tripped while startingECU 17
Engine temperature sensor malfunctionECU 18
Error on ECU throttle sensor connectionECU 22
Atmospheric pressure sensor malfunctionECU 23

Aprilia Instrument Panel Error Codes :

ERROR DESCRIPTIONINSTRUMENT PANEL ERROR CODE
Immobilizer failure: Key code read but not acknowledgedDSB 01
Immobilizer failure: Key code not read (key not available or transponder broken)DSB 02
Immobilizer failure: Broken antenna (open or short-circuited)DSB 03
Immobilizer failure: Inner controller failureDSB 04
Fuel sensor failureDSB 05

Aprilia Climber 280 R Motorcycle Problems :

  • Aprilia climber 280 r after fire
  • Aprilia climber 280 r air cleaner clogged, poorly sealed, or missing
  • Aprilia climber 280 r air cleaner element clogged
  • Aprilia climber 280 r air duct loose
  • Aprilia climber 280 r air suction valve trouble
  • Aprilia climber 280 r air switching valve trouble
  • Aprilia climber 280 r backfiring when deceleration
  • Aprilia climber 280 r cracked or obstructed intake air pressure sensor
  • Aprilia climber 280 r crankshaft sensor trouble
  • Aprilia climber 280 r eCU ground and power supply trouble
  • Aprilia climber 280 r eCU trouble
  • Aprilia climber 280 r engine overheating - Water temperature sensor or crankshaft sensor trouble
  • Aprilia climber 280 r engine stalls easily
  • Aprilia climber 280 r engine vacuum not synchronizing
  • Aprilia climber 280 r exhaust Smokes Excessively
  • Aprilia climber 280 r firing incorrect
  • Aprilia climber 280 r fuel filter clogged
  • Aprilia climber 280 r fuel injector clogged
  • Aprilia climber 280 r fuel injector O-ring damage
  • Aprilia climber 280 r fuel injector trouble
  • Aprilia climber 280 r fuel line clogged
  • Aprilia climber 280 r fuel poor quality or incorrect
  • Aprilia climber 280 r fuel pressure regulator trouble
  • Aprilia climber 280 r fuel pressure too low or too high
  • Aprilia climber 280 r fuel pump bearings may wear. Replace the fuel pump
  • Aprilia climber 280 r fuel pump not operating
  • Aprilia climber 280 r fuel pump operates intermittently and often DFI fuse blows
  • Aprilia climber 280 r fuel pump relay trouble
  • Aprilia climber 280 r fuel pump trouble
  • Aprilia climber 280 r fuel/air mixture incorrect
  • Aprilia climber 280 r fuel/air mixture incorrect
  • Aprilia climber 280 r gear position sensor, starter lockout or side stand switch trouble
  • Aprilia climber 280 r inspect and repair or replace
  • Aprilia climber 280 r intake air pressure sensor trouble
  • Aprilia climber 280 r intake air temperature sensor trouble
  • Aprilia climber 280 r intake air temperature sensor trouble
  • Aprilia climber 280 r intermittent any DFI fault and its recovery
  • Aprilia climber 280 r little fuel in tank
  • Aprilia climber 280 r main throttle sensor trouble
  • Aprilia climber 280 r no or little fuel in tank
  • Aprilia climber 280 r poor acceleration
  • Aprilia climber 280 r spark plug burned or gap maladjusted
  • Aprilia climber 280 r spark plug dirty, broken or gap maladjusted
  • Aprilia climber 280 r spark plug incorrect
  • Aprilia climber 280 r spark weak
  • Aprilia climber 280 r stick coil shorted or not in good contact
  • Aprilia climber 280 r stick coil trouble
  • Aprilia climber 280 r subthrottle sensor trouble
  • Aprilia climber 280 r subthrottle valve actuator trouble
  • Aprilia climber 280 r throttle body assy dust seal damage
  • Aprilia climber 280 r throttle body assy holder loose
  • Aprilia climber 280 r throttle valves will not fully open
  • Aprilia climber 280 r unstable (rough) idling
  • Aprilia climber 280 r unstable fuel pressure
  • Aprilia climber 280 r vacuum hose
  • Aprilia climber 280 r vehicle-down sensor trouble
  • Aprilia climber 280 r water or foreign matter in fuel Change fuel
  • Aprilia climber 280 r water temperature sensor trouble

The electrical system includes the battery, the charging system, the starters, and also the charging system. it's conjointly attainable that the electrical system will fail thanks to a tangle with the generator. an honest place to begin troubleshooting the electrical system is to see the engine elements. for instance, it's attainable that the electrical system will fail thanks to a tangle with the generator. an honest place to begin troubleshooting the electrical system is to see the engine elements.

Possible Failure Types :

  • Strange Aprilia Climber 280 R engine noise.
  • Aprilia Climber 280 R fog from engine.
  • Strange Aprilia Climber 280 R engine noise.
  • Aprilia Climber 280 R Vibrations and Rattling
  • Aprilia Climber 280 R Loud Acceleration
  • Aprilia Climber 280 R rusty exhaust
  • Aprilia Climber 280 R blockages in exhaust pipe
  • Aprilia Climber 280 R wear and tear exhaust
Aprilia Logo

Aprilia was founded directly after WW2 as a manufacturer of bicycles, moving to scooters and motorcycles in 1968. Today, Aprilia enjoys success in the competitive sports and adventure bike segments, as well as competing in a variety of motorcycle racing championships.

Check other Aprilia fault codes.

Common abbreviations and their meanings below:

ABS: Anti-Lock Braking System
ACR: Automatic Compression Release
AFR: Air Fuel Ratio
AIS: Active Intake Solenoid
ATS: Air Temperature Sensor
BAS: Bank Angle Sensor
BCM: Body Control Module
CAN: Controller Area Network
CCM: Cruise Control Module
CKP: Crank Position Sensor
DLC: Datalink Connector
DTC: Diagnostic Trouble Codes
ECM: Electronic Control Module
ECT: Engine Coolant Temperature
ECU: Electronic Control Unit
EFI: Electronic Fuel Injection
EFP: Electronic Fuel Pump
ET: Engine Temperature sensor
FI: Fuel Injectors
FPR: Fuel Pressure Regulator
H-DSSS: Harley-Davidson® Smart Security System
HCU: Hydraulic Control Unit, ABS
HFSM: Hands Free Security Module
HO2S: Heated Oxygen Sensor
IAC: Idle Air Control actuator
IAT: Intake Air Temperature sensor
ICM: Ignition Control Module
IMAP: MAP + IAT in one unit
ISS: Ion Sensing System
JSS: Jiffy Stand Sensor
LHCM: Left Hand Control Module
MAP: Manifold Absolute Pressure sensor
MHR: Right Hand Control Module
RCM: Reverse Control Module
TCA: Throttle Control Actuator
TGS: Twist Grip Sensor
TMAP: Intake Air Temperature / Manifold Absolute Pressure equipment
TPS: Throttle Position Sensor
TSM / TSSM: (Turn Signal / Turn Signal Security Module)
VE: Volume Efficiency
VIN: Vehicle Identification Number
VSS: Vehicle Speed Sensor
WSS: Wheel Speed Sensor

These abbreviations, and the accompanying list of trouble codes, can be a great start when your Aprilia check engine light comes on. As mentioned above, if you are not comfortable with electrical diagnostic work, a dealership or qualified technician can offer assistance. Please keep in mind that even though you have the ability to clear a DTC using the onboard diagnostic feature, you shouldn't clear the code prior to your service appointment. Let the technician view and clear the codes as they troubleshoot the issue.

Aprilia and logo are registered trademarks of Aprilia. We are fan of MOTORCYCLES ! We love them.

Motorcycle electrical systems are very complex to fix it, check with your motorcycle diagnosis tool for the fault code and start motorcycle troubleshooting process.Some bike problems require professional troubleshooting and repair. However, there are many issues that you can easily fix on your own.

About Us | Contact | Privacy

Copyright 2022 - © MotorcycleTroubleshooting.com