Aprilia Moto 6.5 Fault Codes

Aprilia Moto 6.5 motorcycles have engines, which are made up of many different parts. These parts must work together in order for the engine to function. A problem with one of the parts can make the engine not run. There are many different parts that make up an engine. The following aprilia moto 6.5 faults are the list of some of the parts of a motorcycle engine.

One of the most common issues with Aprilia Moto 6.5 motorcycle electrical systems is a clogged battery terminal. This can cause your ride to start having issues with the electrical components. Discolored terminals are often caused by a build-up of corrosion. This will prevent electrons from flowing properly, which reduces your ride’s electrical performance.

Aprilia Moto 6.5 Faults :

Another drawback that may occur along with your bike engine could be a blown gasket. this will cause your engine to overheat and presumably crack the cylinder heads. during this case, it's best to require your Aprilia Moto 6.5 bike to an expert mechanic to possess it verified. Another common drawback is with the carburettor. The carburettor is that the a part of your bike that mixes air and fuel to make the combustion required to power the engine.

Aprilia engine management system is able to self-diagnose faults and tell you what's wrong with it.

To display the Aprilia Fault Codes diagnostics codes, enable diagnostics mode by pressing the LAP button at key-ON for at least 15 seconds. To exit the diagnostics code display and return to the normal display mode, run a key-OFF/ON cycle. When the faults are eliminated and hence the Fault Code is no longer being sent to the dashboard by the ECU, the dashboard will continue to display them until a key-OFF/ON cycle is run. lithe dashboard is sent a code other than those given in the following diagnostics code table, it will display PXX where the XX ls the last iwo digits of the code in question. lf the CAN line does not respond or is disconnected in diagnostics mode, ERR will flash in place of the code digits

Aprilia Error Code List :

Component Fault Code DTC Possible Cause
Camshaft position sensor 11 Sensor not connected.

Sensor broken.

Wiring faulty.

Crankshaft position sensor 12
Intake pressure sensor 13
Intake pressure sensor 14 Excessive pressure difference between two pressure sensors
Throttle position sensor 15 Sensor not connected.

Sensor broken.

Wiring faulty.

Coolant temperature sensor 21
Air temperature sensor 22
Atmospheric pressure sensor (inside ECU) 23 Sensor faulty
Ignition coil 1, Front cylinder 33 Ignition coil faulty or wiring not connected
Ignition coil 2, Front cylinder 34
Ignition coils 1 and 2, Front cylinder 33,34
Ignition coil 1, Rear cylinder 35
Ignition coil 2, Rear cylinder 36
Ignition coils 1 and 2, Rear cylinder 35,36
Fall Sensor (tip-over sensor) 41 Sensor not connected.

Sensor broken.

Wiring faulty.

Aprilia ECU Error Codes

This menu allows you to view any current errors (active) or stored (memo) as detected by the ECU. The presence of an error is indicated by x. To identify the error, please refer to the “ECU error codes” table.

ERROR DESCRIPTION ECU ERROR CODE
Engine overheatECU 01
Pick-up sensor failureECU 02
Wrong signal from throttle position sensorsECU 03
Wrong signal from throttle position sensor 1ECU 04
Wrong signal from throttle position sensor 2ECU 05
Throttle position sensor 1 malfunctionECU 06
Throttle position sensor 2 malfunctionECU 07
Throttle position sensors malfunctionECU 08
Incorrect charging voltageECU 09
Oil pump malfunctionECU 10
Air injector malfunctionECU 11
Fuel injector malfunctionECU 12
Ignition circuit malfunctionECU 13
Fuel pump malfunctionECU 14
Engine rpm limiter trippedECU 15
Error in ECU power supplyECU 16
Rpm limiter tripped while startingECU 17
Engine temperature sensor malfunctionECU 18
Error on ECU throttle sensor connectionECU 22
Atmospheric pressure sensor malfunctionECU 23

Aprilia Instrument Panel Error Codes :

ERROR DESCRIPTIONINSTRUMENT PANEL ERROR CODE
Immobilizer failure: Key code read but not acknowledgedDSB 01
Immobilizer failure: Key code not read (key not available or transponder broken)DSB 02
Immobilizer failure: Broken antenna (open or short-circuited)DSB 03
Immobilizer failure: Inner controller failureDSB 04
Fuel sensor failureDSB 05

Aprilia Moto 6.5 Motorcycle Problems :

  • Aprilia moto 6.5 after fire
  • Aprilia moto 6.5 air cleaner clogged, poorly sealed, or missing
  • Aprilia moto 6.5 air cleaner element clogged
  • Aprilia moto 6.5 air duct loose
  • Aprilia moto 6.5 air suction valve trouble
  • Aprilia moto 6.5 air switching valve trouble
  • Aprilia moto 6.5 backfiring when deceleration
  • Aprilia moto 6.5 cracked or obstructed intake air pressure sensor
  • Aprilia moto 6.5 crankshaft sensor trouble
  • Aprilia moto 6.5 eCU ground and power supply trouble
  • Aprilia moto 6.5 eCU trouble
  • Aprilia moto 6.5 engine overheating - Water temperature sensor or crankshaft sensor trouble
  • Aprilia moto 6.5 engine stalls easily
  • Aprilia moto 6.5 engine vacuum not synchronizing
  • Aprilia moto 6.5 exhaust Smokes Excessively
  • Aprilia moto 6.5 firing incorrect
  • Aprilia moto 6.5 fuel filter clogged
  • Aprilia moto 6.5 fuel injector clogged
  • Aprilia moto 6.5 fuel injector O-ring damage
  • Aprilia moto 6.5 fuel injector trouble
  • Aprilia moto 6.5 fuel line clogged
  • Aprilia moto 6.5 fuel poor quality or incorrect
  • Aprilia moto 6.5 fuel pressure regulator trouble
  • Aprilia moto 6.5 fuel pressure too low or too high
  • Aprilia moto 6.5 fuel pump bearings may wear. Replace the fuel pump
  • Aprilia moto 6.5 fuel pump not operating
  • Aprilia moto 6.5 fuel pump operates intermittently and often DFI fuse blows
  • Aprilia moto 6.5 fuel pump relay trouble
  • Aprilia moto 6.5 fuel pump trouble
  • Aprilia moto 6.5 fuel/air mixture incorrect
  • Aprilia moto 6.5 fuel/air mixture incorrect
  • Aprilia moto 6.5 gear position sensor, starter lockout or side stand switch trouble
  • Aprilia moto 6.5 inspect and repair or replace
  • Aprilia moto 6.5 intake air pressure sensor trouble
  • Aprilia moto 6.5 intake air temperature sensor trouble
  • Aprilia moto 6.5 intake air temperature sensor trouble
  • Aprilia moto 6.5 intermittent any DFI fault and its recovery
  • Aprilia moto 6.5 little fuel in tank
  • Aprilia moto 6.5 main throttle sensor trouble
  • Aprilia moto 6.5 no or little fuel in tank
  • Aprilia moto 6.5 poor acceleration
  • Aprilia moto 6.5 spark plug burned or gap maladjusted
  • Aprilia moto 6.5 spark plug dirty, broken or gap maladjusted
  • Aprilia moto 6.5 spark plug incorrect
  • Aprilia moto 6.5 spark weak
  • Aprilia moto 6.5 stick coil shorted or not in good contact
  • Aprilia moto 6.5 stick coil trouble
  • Aprilia moto 6.5 subthrottle sensor trouble
  • Aprilia moto 6.5 subthrottle valve actuator trouble
  • Aprilia moto 6.5 throttle body assy dust seal damage
  • Aprilia moto 6.5 throttle body assy holder loose
  • Aprilia moto 6.5 throttle valves will not fully open
  • Aprilia moto 6.5 unstable (rough) idling
  • Aprilia moto 6.5 unstable fuel pressure
  • Aprilia moto 6.5 vacuum hose
  • Aprilia moto 6.5 vehicle-down sensor trouble
  • Aprilia moto 6.5 water or foreign matter in fuel Change fuel
  • Aprilia moto 6.5 water temperature sensor trouble

Issues with the engine area unit generally caused by problems with the engine elements. whether or not it's a fuel issue or AN ignition drawback, the engine elements ought to be inspected to work out the cause. Another issue that may occur is once the bike engine isn't operating could be a failure of the electrical system. this will cause the bike to stall and not work properly. The Aprilia Moto 6.5 electrical system is often the foremost complicated system on a motorbike.

Possible Failure Types :

  • Strange Aprilia Moto 6.5 engine noise.
  • Aprilia Moto 6.5 fog from engine.
  • Strange Aprilia Moto 6.5 engine noise.
  • Aprilia Moto 6.5 Vibrations and Rattling
  • Aprilia Moto 6.5 Loud Acceleration
  • Aprilia Moto 6.5 rusty exhaust
  • Aprilia Moto 6.5 blockages in exhaust pipe
  • Aprilia Moto 6.5 wear and tear exhaust
Aprilia Logo

Aprilia was founded directly after WW2 as a manufacturer of bicycles, moving to scooters and motorcycles in 1968. Today, Aprilia enjoys success in the competitive sports and adventure bike segments, as well as competing in a variety of motorcycle racing championships.

Check other Aprilia fault codes.

Common abbreviations and their meanings below:

ABS: Anti-Lock Braking System
ACR: Automatic Compression Release
AFR: Air Fuel Ratio
AIS: Active Intake Solenoid
ATS: Air Temperature Sensor
BAS: Bank Angle Sensor
BCM: Body Control Module
CAN: Controller Area Network
CCM: Cruise Control Module
CKP: Crank Position Sensor
DLC: Datalink Connector
DTC: Diagnostic Trouble Codes
ECM: Electronic Control Module
ECT: Engine Coolant Temperature
ECU: Electronic Control Unit
EFI: Electronic Fuel Injection
EFP: Electronic Fuel Pump
ET: Engine Temperature sensor
FI: Fuel Injectors
FPR: Fuel Pressure Regulator
H-DSSS: Harley-Davidson® Smart Security System
HCU: Hydraulic Control Unit, ABS
HFSM: Hands Free Security Module
HO2S: Heated Oxygen Sensor
IAC: Idle Air Control actuator
IAT: Intake Air Temperature sensor
ICM: Ignition Control Module
IMAP: MAP + IAT in one unit
ISS: Ion Sensing System
JSS: Jiffy Stand Sensor
LHCM: Left Hand Control Module
MAP: Manifold Absolute Pressure sensor
MHR: Right Hand Control Module
RCM: Reverse Control Module
TCA: Throttle Control Actuator
TGS: Twist Grip Sensor
TMAP: Intake Air Temperature / Manifold Absolute Pressure equipment
TPS: Throttle Position Sensor
TSM / TSSM: (Turn Signal / Turn Signal Security Module)
VE: Volume Efficiency
VIN: Vehicle Identification Number
VSS: Vehicle Speed Sensor
WSS: Wheel Speed Sensor

These abbreviations, and the accompanying list of trouble codes, can be a great start when your Aprilia check engine light comes on. As mentioned above, if you are not comfortable with electrical diagnostic work, a dealership or qualified technician can offer assistance. Please keep in mind that even though you have the ability to clear a DTC using the onboard diagnostic feature, you shouldn't clear the code prior to your service appointment. Let the technician view and clear the codes as they troubleshoot the issue.

Aprilia and logo are registered trademarks of Aprilia. We are fan of MOTORCYCLES ! We love them.

Motorcycle electrical systems are very complex to fix it, check with your motorcycle diagnosis tool for the fault code and start motorcycle troubleshooting process.Some bike problems require professional troubleshooting and repair. However, there are many issues that you can easily fix on your own.

About Us | Contact | Privacy

Copyright 2022 - © MotorcycleTroubleshooting.com