Aprilia MX 250 Fault Codes
Aprilia MX 250 motorcycles have engines, which are made up of many different parts. These parts must work together in order for the engine to function. A problem with one of the parts can make the engine not run. There are many different parts that make up an engine. The following aprilia mx 250 faults are the list of some of the parts of a motorcycle engine.
The fault codes are essential to the Aprilia MX 250 motorcycle operation, as they create the spark that ignites the mixture of air and fuel in the engine. Check to see that the spark plugs are not soiled with carbon. As a result, the spark plugs will provide a much weaker spark. The most common cause of soiled spark plugs is the improper installation of an air filter. The air filter prevents dirt from getting into the engine, but a faulty air filter will allow dirt to enter the carburetor.
Aprilia MX 250 Faults :
The warning light comes on when one of the various sensors has detected an abnormal condition in the Aprilia MX 250 engine's performance. For example, if the oil pressure drops below a certain threshold or if the air/fuel ratio rises beyond a certain point, then this would cause an immediate alert from your vehicle's engine management system.
Aprilia engine management system is able to self-diagnose faults and tell you what's wrong with it.
To display the Aprilia Fault Codes diagnostics codes, enable diagnostics mode by pressing the LAP button at key-ON for at least 15 seconds. To exit the diagnostics code display and return to the normal display mode, run a key-OFF/ON cycle. When the faults are eliminated and hence the Fault Code is no longer being sent to the dashboard by the ECU, the dashboard will continue to display them until a key-OFF/ON cycle is run. lithe dashboard is sent a code other than those given in the following diagnostics code table, it will display PXX where the XX ls the last iwo digits of the code in question. lf the CAN line does not respond or is disconnected in diagnostics mode, ERR will flash in place of the code digits
Aprilia Error Code List :
| Component | Fault Code DTC | Possible Cause |
|---|---|---|
| Camshaft position sensor | 11 |
Sensor not connected.
Sensor broken. Wiring faulty. |
| Crankshaft position sensor | 12 | |
| Intake pressure sensor | 13 | |
| Intake pressure sensor | 14 | Excessive pressure difference between two pressure sensors |
| Throttle position sensor | 15 |
Sensor not connected.
Sensor broken. Wiring faulty. |
| Coolant temperature sensor | 21 | |
| Air temperature sensor | 22 | |
| Atmospheric pressure sensor (inside ECU) | 23 | Sensor faulty |
| Ignition coil 1, Front cylinder | 33 | Ignition coil faulty or wiring not connected |
| Ignition coil 2, Front cylinder | 34 | |
| Ignition coils 1 and 2, Front cylinder | 33,34 | |
| Ignition coil 1, Rear cylinder | 35 | |
| Ignition coil 2, Rear cylinder | 36 | |
| Ignition coils 1 and 2, Rear cylinder | 35,36 | |
| Fall Sensor (tip-over sensor) | 41 |
Sensor not connected.
Sensor broken. Wiring faulty. |
Aprilia ECU Error Codes
This menu allows you to view any current errors (active) or stored (memo) as detected by the ECU. The presence of an error is indicated by x. To identify the error, please refer to the ECU error codes table.
| ERROR DESCRIPTION | ECU ERROR CODE |
|---|---|
| Engine overheat | ECU 01 |
| Pick-up sensor failure | ECU 02 |
| Wrong signal from throttle position sensors | ECU 03 |
| Wrong signal from throttle position sensor 1 | ECU 04 |
| Wrong signal from throttle position sensor 2 | ECU 05 |
| Throttle position sensor 1 malfunction | ECU 06 |
| Throttle position sensor 2 malfunction | ECU 07 |
| Throttle position sensors malfunction | ECU 08 |
| Incorrect charging voltage | ECU 09 |
| Oil pump malfunction | ECU 10 |
| Air injector malfunction | ECU 11 |
| Fuel injector malfunction | ECU 12 |
| Ignition circuit malfunction | ECU 13 |
| Fuel pump malfunction | ECU 14 |
| Engine rpm limiter tripped | ECU 15 |
| Error in ECU power supply | ECU 16 |
| Rpm limiter tripped while starting | ECU 17 |
| Engine temperature sensor malfunction | ECU 18 |
| Error on ECU throttle sensor connection | ECU 22 |
| Atmospheric pressure sensor malfunction | ECU 23 |
Aprilia Instrument Panel Error Codes :
| ERROR DESCRIPTION | INSTRUMENT PANEL ERROR CODE |
|---|---|
| Immobilizer failure: Key code read but not acknowledged | DSB 01 |
| Immobilizer failure: Key code not read (key not available or transponder broken) | DSB 02 |
| Immobilizer failure: Broken antenna (open or short-circuited) | DSB 03 |
| Immobilizer failure: Inner controller failure | DSB 04 |
| Fuel sensor failure | DSB 05 |
Aprilia MX 250 Motorcycle Problems :
- Aprilia mx 250 after fire
- Aprilia mx 250 air cleaner clogged, poorly sealed, or missing
- Aprilia mx 250 air cleaner element clogged
- Aprilia mx 250 air duct loose
- Aprilia mx 250 air suction valve trouble
- Aprilia mx 250 air switching valve trouble
- Aprilia mx 250 backfiring when deceleration
- Aprilia mx 250 cracked or obstructed intake air pressure sensor
- Aprilia mx 250 crankshaft sensor trouble
- Aprilia mx 250 eCU ground and power supply trouble
- Aprilia mx 250 eCU trouble
- Aprilia mx 250 engine overheating - Water temperature sensor or crankshaft sensor trouble
- Aprilia mx 250 engine stalls easily
- Aprilia mx 250 engine vacuum not synchronizing
- Aprilia mx 250 exhaust Smokes Excessively
- Aprilia mx 250 firing incorrect
- Aprilia mx 250 fuel filter clogged
- Aprilia mx 250 fuel injector clogged
- Aprilia mx 250 fuel injector O-ring damage
- Aprilia mx 250 fuel injector trouble
- Aprilia mx 250 fuel line clogged
- Aprilia mx 250 fuel poor quality or incorrect
- Aprilia mx 250 fuel pressure regulator trouble
- Aprilia mx 250 fuel pressure too low or too high
- Aprilia mx 250 fuel pump bearings may wear. Replace the fuel pump
- Aprilia mx 250 fuel pump not operating
- Aprilia mx 250 fuel pump operates intermittently and often DFI fuse blows
- Aprilia mx 250 fuel pump relay trouble
- Aprilia mx 250 fuel pump trouble
- Aprilia mx 250 fuel/air mixture incorrect
- Aprilia mx 250 fuel/air mixture incorrect
- Aprilia mx 250 gear position sensor, starter lockout or side stand switch trouble
- Aprilia mx 250 inspect and repair or replace
- Aprilia mx 250 intake air pressure sensor trouble
- Aprilia mx 250 intake air temperature sensor trouble
- Aprilia mx 250 intake air temperature sensor trouble
- Aprilia mx 250 intermittent any DFI fault and its recovery
- Aprilia mx 250 little fuel in tank
- Aprilia mx 250 main throttle sensor trouble
- Aprilia mx 250 no or little fuel in tank
- Aprilia mx 250 poor acceleration
- Aprilia mx 250 spark plug burned or gap maladjusted
- Aprilia mx 250 spark plug dirty, broken or gap maladjusted
- Aprilia mx 250 spark plug incorrect
- Aprilia mx 250 spark weak
- Aprilia mx 250 stick coil shorted or not in good contact
- Aprilia mx 250 stick coil trouble
- Aprilia mx 250 subthrottle sensor trouble
- Aprilia mx 250 subthrottle valve actuator trouble
- Aprilia mx 250 throttle body assy dust seal damage
- Aprilia mx 250 throttle body assy holder loose
- Aprilia mx 250 throttle valves will not fully open
- Aprilia mx 250 unstable (rough) idling
- Aprilia mx 250 unstable fuel pressure
- Aprilia mx 250 vacuum hose
- Aprilia mx 250 vehicle-down sensor trouble
- Aprilia mx 250 water or foreign matter in fuel Change fuel
- Aprilia mx 250 water temperature sensor trouble
The first sign that your Aprilia MX 250 motorcycle's starter system is working well is the warning light that appears when you switch on the ignition. It will illuminate for a few seconds, and then go out. This is a good sign that your starter system is working properly and you'll be able to start your motorcycle without difficulty.
Possible Failure Types :
- Strange Aprilia MX 250 engine noise.
- Aprilia MX 250 fog from engine.
- Strange Aprilia MX 250 engine noise.
- Aprilia MX 250 Vibrations and Rattling
- Aprilia MX 250 Loud Acceleration
- Aprilia MX 250 rusty exhaust
- Aprilia MX 250 blockages in exhaust pipe
- Aprilia MX 250 wear and tear exhaust
Aprilia was founded directly after WW2 as a manufacturer of bicycles, moving to scooters and motorcycles in 1968. Today, Aprilia enjoys success in the competitive sports and adventure bike segments, as well as competing in a variety of motorcycle racing championships.
Check other Aprilia fault codes.Common abbreviations and their meanings below:
ABS: Anti-Lock Braking System ACR: Automatic Compression Release AFR: Air Fuel Ratio AIS: Active Intake Solenoid ATS: Air Temperature Sensor BAS: Bank Angle Sensor BCM: Body Control Module CAN: Controller Area Network CCM: Cruise Control Module CKP: Crank Position Sensor DLC: Datalink Connector DTC: Diagnostic Trouble Codes ECM: Electronic Control Module ECT: Engine Coolant Temperature ECU: Electronic Control Unit EFI: Electronic Fuel Injection EFP: Electronic Fuel Pump ET: Engine Temperature sensor FI: Fuel Injectors FPR: Fuel Pressure Regulator H-DSSS: Harley-Davidson® Smart Security System HCU: Hydraulic Control Unit, ABS HFSM: Hands Free Security Module HO2S: Heated Oxygen Sensor IAC: Idle Air Control actuator IAT: Intake Air Temperature sensor ICM: Ignition Control Module IMAP: MAP + IAT in one unit ISS: Ion Sensing System JSS: Jiffy Stand Sensor LHCM: Left Hand Control Module MAP: Manifold Absolute Pressure sensor MHR: Right Hand Control Module RCM: Reverse Control Module TCA: Throttle Control Actuator TGS: Twist Grip Sensor TMAP: Intake Air Temperature / Manifold Absolute Pressure equipment TPS: Throttle Position Sensor TSM / TSSM: (Turn Signal / Turn Signal Security Module) VE: Volume Efficiency VIN: Vehicle Identification Number VSS: Vehicle Speed Sensor WSS: Wheel Speed Sensor
These abbreviations, and the accompanying list of trouble codes, can be a great start when your Aprilia check engine light comes on. As mentioned above, if you are not comfortable with electrical diagnostic work, a dealership or qualified technician can offer assistance. Please keep in mind that even though you have the ability to clear a DTC using the onboard diagnostic feature, you shouldn't clear the code prior to your service appointment. Let the technician view and clear the codes as they troubleshoot the issue.
Aprilia and logo are registered trademarks of Aprilia. We are fan of MOTORCYCLES ! We love them.